-
الماسح الضوئي obd للشاحنات الثقيلة
-
رافعة شوكيّة أدوات التشخيص
-
واجب ثقيل شاحنة الماسح التشخيص
-
أداة مسح الإرسال
-
مبرمج لجهاز التحكم في الكهرباء
-
تكييف رقاقة ECU
-
أداة تشخيص نجمة مرسيدس بنز
-
جهاز المسح التشخيصي للمحفر
-
أداة تشخيص Vocom
-
إطلاق جهاز فحص تشخيص شاحنة ثقيلة X431
-
المبرمج الرئيسي لـ CGDI
-
أوتيل ماكسيسيس ماسح التشخيصي
-
ماسح تشخيصي للسيارات
-
أداة تشخيص الشاحنة
-
أدوات التشخيص الزراعية
-
آلة قطع مفاتيح الحصان
-
مبرمج مفتاح Obdstar
-
أداة تشخيص الدراجة النارية
-
Jim.Mشحن ممتاز. سيتمّ إستجابة سريع جدّا إلى سؤال AAA+++++ بائع عمل مع ثانية. -
Giovanni s.venditore فائق, affidabile, veloce سل spedizione ..... insomma tutto ok: -) -
Rayner lشكرا. أنا سعيد جداً مع المنتج. وقد وصل إلى كل شيء في حالة ممتازة.
ECU Flasher ECU Tuning Programming Tools for T\o\yota/Le\x\us READ WRITE Via Internal 20 Pin or 26 Pin Connector
| اسم النموذج | وحدة نقدية أوروبية المتعري | نوع النموذج | مبرمج وحدة نقدية أوروبية |
|---|---|---|---|
| الضمان | سنة واحدة | متعدد اللغات | الإنجليزية والفرنسية والصينية المبسطة |
| نوع العنصر | محلل المحرك | يكتب | قارئات الكود وأدوات المسح الضوئي |
| مزيج | لتويوتا مفتاح ذكي مبرمج | الوظيفة 1 | قراءة وكتابة بيانات وحدة التحكم الإلكترونية |
| الوظيفة 2 | تعديل معلمة وحدة التحكم الإلكترونية | الوظيفة 3 | هندسة صيانة وحدة التحكم الإلكترونية |
| نماذج قابلة للتطبيق | لتويوتا ولكزس |
New ECU Flasher Tool For Toyota / Lexus Read Write ECU Programmer For Denso and Fujitsu Ten ECUs Support 2015+ With NEC Chip
Description:
For Toyota Flasher, a joint project by Autokey and P.C.M.flash, is a multipurpose programmer for Denso and Fujitsu Ten ECUs with NEC processors installed For TOYOTA/LEXUS/SCION vehicles with petrol and diesel engines through JTAG interface. OBD writing via CAN bus is supported. It is a unique solution in the chip tuning world. It covers almost all the models beginning from 2003-2004. It can read, flash, clear, verificate internal flash memory of microcontrollers if connected to the appropriate connector on the ECU circuit board.
Advantages:
·Its own hardware interface allows to avoid all compatibility and driver problems;
·Work through built-in 20 or 26 pin JTAG connector;
·Full access to the ECU memory at high speed of more than 100 KB/s;
·Saving files in the open format;
·Firmware checksum verification and recalculation.
·SUPPORT 2015 + OBD WRITE and SOME MODELS 2015 + OBD READ
·can READ and WRITE via internal 20 pin or 26 pin connector. connection diagram for all known
Supported ECUs:
For TOYOTA DENSO ENGINE CONTROL MODULE based on NEC 7F00XX series MCU :
76F0038
7F0038A
76F0039
76F0039A
76F0040
76F0040A
76F0070 BGA
76F0085 BGA
saving in normal mode without any master-slave.
master only.
auto CHECKSUM CORRECTION support
These processors were introduced at the beginning of CAN support and as a rule with coachwork change.
Package List:
1pc*Host device of forToyota forLexus Denso ECU Flasher
1pc*12V/3A power out
1pc*16pin cable for ecu reding by OBD
1pc*cable for BDM function
1pc*adapter for mitsubshi reading by boot
1pc*USB cable to connect the tool to computer
1pc*adapter
pcs*pins
1pc*Suitcase
بطاقة:

